
Comparing the new VXC Stepper Motor Controller to the VXM
VXC/VXM Reliability and Warranty Comparison
Yes, the VXC is a tested ready to run integrated motor control/motor drive/power supply/user interface component for Velmex supplied motors, linear, and rotary assemblies.
Yes, like the VXM, the VXC has an oversized motor drive and the same High-Performance RISC CPU. The firmware, circuit board, and enclosure were developed by the Velmex VXM product engineer. Additionally, the new VXC is designed to meet modern international compliance standards.
Yes, Velmex backs its electronic products with a 2-year warranty.
Yes, the VXC should provide years of trouble-free performance.
VXC/VXM Programming & Setting Comparison
Yes, the basic motion commands are the same. Programs written for the VXM are compatible with the VXC. Refer to the VXC User’s Manual Appendix P for comparison.
Yes, in addition to using the same basic motion commands, the VXC has a VXM mode setting that makes the VXC backwards compatible for pause units and program number jump interrupts. Refer to the VXC User’s Manual Appendix H for VXM mode setting.
Data bits and stop bits are the same. The VXC default baud rate is 57,600 for the VXC versus 9,600 for the VXM. VXC baud rate can be easily set to match the VXM. Refer to the VXC User’s Manual Appendix O for setting the baud rate.
The motor setting command/values are different since the VXC is mainly for new 4-wire bipolar motors. The limit setting values are the same with more options. Velmex will preconfigure the motor setting and limit switch settings so you do not have to set them. All new motor driven units sold by Velmex have a device ID number that you simply enter into the VXC App to configure the control for the correct motor/limit/home settings. Refer to the VXC User’s Manual Appendix P.
VXC/VXM Mechanical Comparison
Yes, The VXC is smaller than the VXM. The VXC uses cleats to mount it upright to a surface or add-on flanges for sideways mounting, versus T-nut mounting on the top/bottom for the VXM.
Yes, the VXC can run the 6-wire hybrid stepping motors. However, its bipolar motor drive will produce higher performance with the new 4-wire motors.
Yes, the VXC has a higher efficiency motor drive that produces more torque and less heat.
Yes, the VXC, with its microstepping, is quieter and has lower vibration at low speeds. Additionally, the VXC has a 40% power setting to reduce noise and vibration for light load applications.
Yes, the VXC is an all-aluminum alloy enclosure.
VXC/VXM Electrical Comparison
As an option, a RS-232 port (9 pin D-sub) connection on the back is available. The VXC normally has a USB and RS-422/232 serial ports on the front panel.
No, the VXC uses a new 4 pin connector. Velmex has conversion adapters to connect the VXC to older 6-wire motors.
No, the VXC uses 8-wire limit cables with RJ45 connectors on each end. On request, Velmex will provide the limit cable with the VXM (4-pin) limit connector.
Yes, the same voltage but using a higher 70-watt power supply with a (2.1×5.5) barrel connector.